Instruction Of Peanut Peeling Machine
Author:admin
Date : 2015-12-18
1.Working Principle
The soaked rice, beans, benevolence into the hopper by shaking the raw material into three fixed-powered roller tire rotation, through the induction of the feed wheel role knife by the blade on the raw skin incision, then the material round after peeling the rice, benevolence, beans pressed into the hopper and the hopper discharge, through the rejection leather jacket thrown round.
2.Installation and Commissioning
Mounted on flat ground, ground screw fixation, or more than 10mm legs padded rubber mats.
Required by the electric motor, the power is on, tap the switch, check the direction of rotation is correct (see the rotation direction of the V-belt big wheel mark), add water after the power is turned on, the machine is running five minutes after the start of work (the machine must be kept for too long the correct direction of rotation by hand one to two laps before turning the boot).
3.Technical Parameters
| Project | Almond | Almond | Broad Bean | Soybean |
| Capacity（kg/h） | 200-220 | 200-220 | 300 | 150 |
| Peeling rate（%） | 98±1 | 92-95 | 92-95 | 92±1 |
| Broken rate（%） | 3±1 | 3±1 | 3±1 | 2 |
| Whole kernel rate（%） | 85-95 | 88±2 | 76±2 | - |
| Input Power | 0.75kw（220V, 380V optional） | |||
| Dimensions | Length * width * height=1080×800×1100（mm） | |||
4.Note
1.Non-inversion
2.Equipment must be installed the ground wire
3.All parts of the screws should be firmed again before the new machine turn on,especially the parts of the set screws should be pay more attention to.
4.Bearings must be greased once a week
5.Should to keep the machine clean and do the cleaning periodical.
Attach:Parts Schematic of the peeling machine